home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
SGI Developer Toolbox 6.1
/
SGI Developer Toolbox 6.1 - Disc 4.iso
/
public
/
fax
/
src
/
etc
/
config.dsi-scout+
< prev
next >
Wrap
Text File
|
1994-08-01
|
2KB
|
48 lines
# $Header: /usr/people/sam/fax/etc/RCS/config.dsi-scout+,v 1.13 1993/09/27 11:11:56 sam Rel $
#
# Configuration for using the Class 1 command interface with
# a Digicom Systems, Inc (DSI) Scout+ modem. Firmware version
# 2A19/2931 (ati1?) or newer.
#
# XON/XOFF flow control must be used in firmware revisions before
# 3507/3506 because the modem does not honor RTS/CTS during page
# transfers. Later revisions permit the configuration of RTS/CTS
# flow control through a new (undocument) register, S24:
#
# Value Meaning
# 0 use XON/XOFF in fax mode
# 1 use RTS/CTS in fax mode
# 2 use what is specified by *F in fax mode
#
# Note also that the value of S24 is not permanent. It is reset
# after each disconnect. On power on S24 is 0. S24 is unchanged
# by the &F command.
#
# CONFIG: CLASS1: 961: Manufacturer=Digicom Model=Scout+
#
CountryCode: 1 # USA
LongDistancePrefix: 1
InternationalPrefix: 011
AreaCode: 415
DialStringRules: etc/dialrules
FAXNumber: +1.415.965.7824
ServerTracing: 1
SessionTracing: 11
RecvFileMode: 0600
LogFileMode: 0600 # private log files
DeviceMode: 0600 # device is accessible only to uucp/fax
SpeakerVolume: off
RingsBeforeAnswer: 1 # answer on first ring
#
ModemType: Class1 # hint to override class 2
ModemMaxRate: 38400 # could probably run 57600
ModemFlowControl: xonxoff
ModemFlowControlCmd: *F2 # software flow control
ModemSetupDTRCmd: &D3 # DTR off causes modem to reset
ModemSetupDCDCmd: &C1 # DCD follows carrier
ModemMfrQueryCmd: !Digicom
ModemModelQueryCmd: !Scout+
ModemRevQueryCmd: I1
#
ModemDialCmd: DT%s@ # T for tone dialing, @ for silence